MOUNT MAKER / BETA 0.9.2
FPV camera mounts built around your standoffs
Adapt your flight camera to the space between your frame’s standoffs. Generate a pair of tabs with measured camera width, mounting holes, and a fixed or adjustable tilt layout.
Windows x64 · Free demo · STL export in the full version
A tab for each side
Mount over your existing standoffs and adjust the camera mounting width inward or outward. No source STL is required.
Fixed holes or curved slots
Use one M2 screw per side, or a two-screw layout with fixed holes, a pivot and arc, or two arcs.
Movement guides
Sweep the approximate camera guide through the tilt range to inspect clearance. The guide does not reproduce your lens, wires, or frame cutouts.
BEFORE YOU START
Measure the actual build.
- Standoff center spacing, diameter, and available sleeve height
- Camera width, body dimensions, and M2 screw positions
- Desired tilt range and clearance between the frame plates
The preview helps you design the part. Printed fit, retention, and strength still depend on your measurements, material, and printer.
From dimensions to STL
Measure camera and frame
Enter standoff dimensions and camera width, then choose one or two screws per side.
Choose the tilt layout
Set screw positions and the desired movement range. Review the guide and inspect your real hardware.
Print the tabs you need
Export the pair, left tab, or right tab in the full version. Test TPU fit and retention on the actual build.
Questions about fpv camera soft mounts
Do these replace my frame standoffs?
No. The printed sleeves fit over existing standoffs. Use your actual standoff diameter, spacing, and available height.
Can I export just one camera tab?
Yes. The Print parts setting offers both tabs, left only, or right only. A saved project keeps the full editable pair.
Are these tuned vibration isolators?
The tabs use solid connecting arms rather than a tuned shock-absorbing pattern. Material, printed fit, and vibration behavior need testing on your build.
Make your own fpv camera soft mounts.
Try the design tools in the free demo. Save your project and export printable STLs with the full version.
Get Mount Maker on itch.io