DESIGN IN MOUNT MAKER
Custom FPV parts.
Ready for your measurements.
Mount Maker is Windows software for designing 3D-printable drone parts. Choose a tool, enter your dimensions, and export an STL in the full version. Start with the free demo to try the workflow.
Action camera mounts
Design an FPV action camera mount around your camera sleeve, bolt pattern, and tilt angle. Save an editable project and export an STL with Mount Maker.
FPV camera soft mounts
Create paired FPV camera mounting tabs with measured standoff spacing, camera width, and fixed or adjustable tilt. Export both tabs or one side as an STL.
Arm protectors
Trace a drone arm from a calibrated photo or SVG drawing. Set screw holes, carbon thickness, shaft clearance, and fit to create a custom arm protector STL.
Antenna & GPS mounts
Design a rear FPV mount with antenna tubes or SMA fittings, a GPS tray, T-antenna holder, and optional power holder. Size it around your frame and hardware.
Whoop canopies
Design a whoop canopy with a measured mounting pattern, camera fit, electronics space, and antenna holders. Preview the layout and export a custom STL.
XT connector mounts
Make a standalone XT30, XT60, or XT90 connector holder for one or two drone standoffs. Adjust housing fit, wire clearance, and retention before STL export.
Electronics trays
Design a measured tray for an FPV receiver, GPS, or beeper. Choose zip ties or bolts, set retaining lips and cable openings, and export a printable STL.
Already have a project open? The handbook covers the controls, fit checks, and export steps.
Read the documentation →